ENGLISH
Minor problems often can be xed without calling
customer service.
TROUBLESHOOTING
PROBLEM SOLUTION
Motor does not run
Check power cord, plugs and outlet.
Ensure the on/off switch is in the
ON position( I ).
Remove blockages in the suction
nozzle, suction tube, suction hose
or lters.
Replace the paper or eece dust bag.
Clean or replace the lters.
Empty the dust tank, refer to Empty
the tank under Operating
instructions.
Check for proper installation of the
lters.
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the dust tank, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position( I )to
test. If vacuum will not restart
call 1-888-899-0146
Ensure lters are not damaged;
replace if necessary.
Ensure lter seals are in place and
are secure.
Check for proper installation of the
lters.
Dust comes out
while vacuuming
6
To Next Page
Loading...
Need help?
General
