English
NOTE
If the filter has been used for wet pick-up, it must be cleaned and
dried before using for dry pick-up.
INSTALLING THE DISPOSABLE FILTER BAG
1. Slide the cardboard collar opening firmly onto the vacuum port
deflector until it stops against the deflector wall.
2. Position the bag so that it is distributed around the inside of the
tank.
3. Replace and secure the power head onto the tank.
WET PICK-UP
Remove all dirt and debris found in the tank. The vacuum requires
only a minimum of conversion when going from dry to wet pick up.
Remove all dry use filter from the vacuum. A clean cartridge filter
may used for vacuuming small amounts of liquids. For best results
when vacuuming large quantities of liquid, remove the cartridge
filter. When vacuuming liquids containing debris, it is recommended
purchasing a foam filter and install over filter cage. Foam filter may
be purchased by visiting our website at www.dewalt.com, contacting
our customer service department, or purchasing at your local
DEWALT distributor. When picking up large amounts of liquid we
recommend that the filter be removed. If the filter is not removed,
it will become saturated and misting may appear in the exhaust.
At this time, you should dry
or replace the cartridge filter to
eliminate the misting and possible dripping of liquid around the lid.
After completing a wet pick-up job, raise the hose to drain any
excess liquid into the tank before shutting off. The interior of tank
should be periodically cleaned.
1. Always disconnect the plug from the wall outlet before removing
the power head. Place power head in an upside down position.
Remove cartridge filte
r by sliding it up and off the filter cage.
2. Shake excess dust off cartridge filter with a rapid up and down
movement.
NOTE:
WET PICK-UP ACCESSORIES SHOULD BE WASHED
PERIODICALLY, ESPECIALLY AFTER PICKING UP WET,
STICKY KITCHEN ACCIDENTS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF SOAP AND
WATER.
4. To clean the cartridge filter, shake or brush off excess dirt or
rinse (from the inside of the filter) with
water, dry completely
(approximately 24 hours) and re-install.
8
Disposable
dust bag
Lock
To Next Page
Loading...
Need help?
General
