English
9
BLOWING OPERATION
WARNING!
Always wear safety goggles complying with ANSI Z87.1 (or in
Canada CSA Z94.3) when using as a blower.
WARNING!
To avoid injury to bystanders, keep them clear of blowing debris.
CAUTION
Wear a dust mask if blowing creates dust which might be inhaled.
CAUTION
To reduce the risk of hearing loss, wear ear protectors when
using the vac/blower for extended hours or when using it in a
noisy area.
Your vac contains a blowing feature. It has the capability to blow
sawdust and other debris. It can be used to blow dust and debris
out of garages or off patios and driveways. Follow the steps
below to use your vac as a blower.
2. Dump the tank contents into the proper waste disposal
container.
pulling outward on the lid clips located on each side of the vac.
Lift off the power head assembly.
EMPTY THE TANK
WARNING!
To reduce the risk of injury from accidental starting, unplug
power cord before emptying the dust tank.
1. Remove the power head assembly of the wet/dry vac by
NOTE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM
COULD CLOSED SUCTION. IF THIS OCCURS, PLACE VAC
IN UPRIGHT POSITION AND TURN SWITCH OFF. THIS WILL
ALLOW THE FLOAT TO RETURN TO ITS NORMAL POSITION,
AND YOU WILL BE ABLE TO CONTINUE OPERATION.
Float in raised position
3. This wet/dry vac is equipped with a float mechanism which will
rise automatically to cut off the airflow when the liquid in the
tank reaches a predetermined level. When this happens, turn
off vac, unplug the power cord, and empty the dust tank. You
will know that the float has shut the airflow off because the
suction ceases and the motor noise becomes higher in pitch
due to increased motor speed. The liquid capacity may
vary
with the rate of pickup.
IMPORTANT:
To reduce the risk of damage to the vac, do not
run motor with float in raised position.
To Next Page
Loading...
Need help?
General
