7
BATTERY CHARGING INSTRUCTIONS
BATTERY CHARGER
• This Class B digital apparatus complies with Canadian ICES-003.
•
This device complies with Part 15 of the FCC Rules and Industry Canada License-
exempt RSS standard(s). Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may
cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
BATTERY CHARGING
Your tool uses a DeWALT charger.
Be sure to read all safety
instructions before using your charger.
1. Plug the charger into an appropriate outlet before inserting
the battery pack.
2.
Insert the battery pack
E
into the charger, making sure the
pack is fully seated in charger. The red light will blink
continuously, indicating the charging process has started.
3.
The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and
may be used at this time or left in the charger.
ENGLISH
6) Battery Tool Use and Care
a)
suitable for one type of batter
another type of battery pack.
b) Use pow
er tools only with specifically d
battery packs may create a risk of injur
c) When batter
connection from one terminal to another
may cause burns or a fire.
d)
irritation or burns.
7) Service
a) Have your power tool ser
E
BAT20CW-1390355ART.indd 7
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
