35
ENGLISH
EC-Declaration of Conformity
Machinery Directive
Cordless Circular Saw
DCS570
declares that these products described under
Technical Data are in compliance with: 2006/42/EC, EN60745-
1:2009+A11:2010, EN60745-1:2009+A11:2010,
EN60745-2-5:2010.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact
at
the following address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
.
Markus Rompel
Director Engineering
, Richard-Klinger-Straße 11,
D-65510, Idstein, Germany
09.12.2016
WARNING: To reduce the risk of injury, read the
instructionmanual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.
Denotes risk of electricshock.
Denotes risk offire.
Congratulations!
You have chosen a
tool. Years of experience, thorough
product development and innovation make
one of the
most reliable partners for professional power toolusers.
Technical Data
DCS570
Voltage V
DC
18
Type 1
Battery type Li-Ion
No-load speed min
-1
5500
Blade diameter mm
184
Maximum depth of cut mm
64
Blade bore
mm
16
(-XE: 20 mm)
Bevel angle adjustment °
57
Weight (without battery pack) kg 3.6
Noise values and vibration values (triax vector sum) according to EN60745-2-5:
L
PA
(emission sound pressure level) dB(A) 91
L
WA
(sound power level) dB(A) 102
K (uncertainty for the given sound level) dB(A) 3
Vibration emission value a
h, W
= m/s
2
<2.5
Uncertainty K = m/s
2
1.5
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given in
EN60745 and may be used to compare one tool with another. It
may be used for a preliminary assessment ofexposure.
WARNING: The declared vibration emission level
represents the main applications of the tool. However if
the tool is used for different applications, with different
accessories or poorly maintained, the vibration emission
may differ. This may significantly increase the exposure
level over the total workingperiod.
An estimation of the level of exposure to vibration should
also take into account the times when the tool is switched
off or when it is running but not actually doing the job.
This may significantly reduce the exposure level over the
total workingperiod.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool
and the accessories, keep the hands warm, organisation
of workpatterns.
English (original instructions)
184 mm CORDLESS CIRCULAR SAW
DCS570
To Next Page
Loading...
Need help?
General