Digikeijs DR5088RC DIGIDETECT User Manual

DR5088RC DIGIDETECT 30.05.2019
P 20
www.digikeijs.com
4.1 Properes Loconet
1) Slow module ming. Can be acvated for problems with Loconet components from other manufacturers.
2) Baudrate tuning. Used to adjust the exact baud rate in Loconet.*
3) Komperator tuning. Here the edge steepness and the edge height can be adjusted.*
4) RailCom Report. Here you can select the LocoNet commands with which the RailCom message is to be sent.
MULTI_SENSE_Standard The original OPC_MULTI_SENSE command is used (Digitrax and Bluecher compable).
The address ranges "locomove address or block address" are restricted if the derailment direcon is to be sent.
MULTI_SENSE_Long The new OPC_MULTI_SENSE_L command is used: No restricon of the address ranges.
MULTI_SENSE_Both Both commands (Long and Standard) are transmied to the central unit.
5) RailCom Sense direcon. Here you select how the derailment direcon is reported to the control centre in the case of "MULTI_SENSE_Standard.
Aus No direcon is transmied.
in Blockadress The track-laying direcon is transmied in the block address (restricon of the block addresses to a maximum of 2048).
in Lokadress The track-laying direcon is transmied in the locomove address (restricon of locomove addresses to a maximum of
4095).
1
2
4
5
3
*Note! Only experienced users should make changes here.
to make a decision.

Digikeijs DR5088RC DIGIDETECT Specifications

General

Brand	Digikeijs
Model	DR5088RC DIGIDETECT
Category	Toy
Language	English