DigiTech BASS DRIVER User Manual

Battery Replacement
1. Using the tip of a 1/4” cable, push one of the release pins in on either
side of the pedal, and remove the pedal from the pedal chassis.
2. Remove the battery from the battery compartment and disconnect
the battery cable.
3. Connect a new battery to the battery cable and put it back in the
battery compartment. Make sure the battery cable does not interfere
with the spring or pedal switch arm.
4. Place one hole of the pedal over its corresponding pin.
5. Push the opposite pin in and lower the other side of the pedal into
place over the depressed pin. Release the pin. When the pedal is
properly fastened, both released pins are flush with the outer side of
the pedal.

DigiTech BASS DRIVER Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Impedance

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 50Hz), PS200R - 240 (240V ~ 50Hz)

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs