DigiTech HARDWIRE HT-6 User Manual

13
3. If a string is in tune, the three center LEDs (yellow-blue-yellow) will light
on the corresponding string’s row. If a string is flat, LEDs to the left of
the center blue LED will light. If a string is sharp, LEDs to the right of
the center blue LED will light.
4. Tune the strings up or down as needed until each of the center blue
LEDs are lit. If some rows are not displaying LEDs, mute and then
strum again until all rows are lighting up.
5. When tuning is complete, press the Foot Switch to bypass the tuner.
TROUBLESHOOTING TIP: If the tuner is not responding as expected, it may be that the
Tuning Display Mode (i.e. Bass, Guitar or Custom), the Tuning Reference, or the Fret Offset is set
incorrectly. If you are experiencing problems try this:
1. Select the correct Tuning Mode for your application (see page 9).
2. Configure the pedal for the desired Tuning Reference (see page 10).
3. Assign the Fret Offset if using a capo or other lowered tuning (see page 21).

DigiTech HARDWIRE HT-6 Specifications

General

Brand	DigiTech
Model	HARDWIRE HT-6
Category	Tuner
Language	English