5
effect then fed to Outputs 1 and 2 keeping true stereo separation
between channels.
Foot Switch Release Pins - These two pins are spring loaded
hinges that hold the Foot Switch in place. See page 10 for informa-
tion on accessing and changing the battery. See page 6 for more
information about using and changing the Tails Switch settings.
Indicator LED - Lights when the effect is turned on. When bat-
tery power is low (approximately 15 minutes), the Indicator LED
begins to dim giving you advanced warning that very shortly you
will need to replace the battery.
Foot Switch - Turns the effect on and off.
Output 1 (Mono) - Connect this output to the input of a single
guitar amplifier or amp effects return.
Output 2 - Connect this output to the input of a second guitar
amplifier when a second amp is being used.
Note: Use unbalanced mono instrument cables only.
8.
9.
10.
11.
12.
To Next Page
Loading...
Need help?
General
