Page 13
Calibrating the Expression Pedal
In the unlikely event that the Expression Pedal does not respond properly or that the note does
not bend or return to the correct pitch, it may need to be re-calibrated. The following steps outline
the procedure for Expression Pedal re-calibration:
1. Disconnect the power from the Whammy pedal.
2. Press and hold the WHAMMY Effect Footswitch while reconnecting the power. This
enables MIDI and Calibration Setup. Wait for one of the WHAMMY Effect LEDs to
begin flashing (indicating the currently selected MIDI channel) then release the footswitch.
3. Rock the Expression Pedal fully forward (toe down) and fully back (toe up) at least two
times. The 4 HARMONY LEDs will light back and forth (from 5TH UP/7TH UP to OCT
DN/OCT UP) as the pedal is rocked indicating the pedal is calibrating.
4. When finished, press the WHAMMY Effect Footswitch again to exit the MIDI and
Calibration set up and return to normal operation.
To Next Page
Loading...
Need help?
General
