8
SAT Auto-Tune
Make sure the remote control
operates your TV.
Press and hold TV POWER until
red light comes on. Release TV
POWER. Red light blinks.
Press and release RECALL.
Enter the channel used for
viewing (three digits in range
of 002 to 125), for example
channel “003.”
Press and release OK.
1
2
3
4
5
Setting SAT Auto-Tune Channel
SAT Auto-Tune programs into the remote control
the correct TV channel used for viewing your paid
programming. If you are experiencing fuzzy, blue, or
black screens, it might be due to the TV being set to the
wrong channel. Using the SAT Auto-Tune feature helps
prevent fuzzy, blue, or black screens from occurring.
When TV POWER is pressed and released, the remote
sends that channel to the TV, ensuring that the TV is on
the correct channel for viewing your paid programming.
To use this feature, you must program the channel
by following the steps under Setting SAT Auto-Tune
Channel.
To Next Page
Loading...
Need help?
General
