To Next Page

To Previous Page

Remote Controller Operations

Checking the Battery Level

Press the power button once to check the current battery level.

Powering On/O

Press and then press again and hold to power the remote controller on or o.

Linking the Remote Controller

The aircraft and remote controller must be linked before use. Follow these steps to link a new remote

controller.

Method 1:

1. Power on the remote controller and the aircraft.

2. Press the C1, C2, and record button simultaneously until the status LED blinks blue and the remote

controller beeps.

3. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps once

to indicate it is ready to link. The aircraft beeps twice to indicate linking is successful. The battery

level LEDs of the remote controller will glow solid.

Method 2:

1. Power on the remote controller and the aircraft.

2. Launch DJI Fly.

3. In camera view, tap and select Control and Pair to Aircraft (Link).

4. Press and hold the power button of the aircraft for more than four seconds. The aircraft beeps once

indicating it is ready to link. The aircraft beeps twice indicating linking is successful. The battery level

LEDs of the remote controller will glow solid.

Make sure the remote controller is within 1.6 ft (0.5 m) of the aircraft during linking.

Make sure the remote controller is connected to the internet when logging in using a DJI account.

Low HighBattery

Other manuals for dji RC Pro

Questions and Answers:

Need help?

Do you have a question about the dji RC Pro and is the answer not in the manual?

General