Troubleshooting HiPro
18
Poor cooling perfor-
mance
Cooling unit not sufficiently ventilated Provide sufficient ventila-
tion, see Installation
Manual
Minibar exposed to direct sunlight Take minibar out of direct
sunlight
Door of minibar not closed with a
tight seal
Check distances, see
Installation Manual
Contact service agent.
Service agent: Replace
door seal
Minibar recently filled Check cooling again after
5 to 6 hours
For versions with absorber cool-
ing: The input voltage is too low or
high.
Check input voltage
Frost formation in the
minibar compartment
Door of minibar not closed with a
tight seal
Check distances, see
Installation Manual
Contact service agent.
Service agent: Replace
door seal
Interior lighting not
working
Power plug not plugged in Insert power plug into
socket
Interior lighting is defective Contact service agent.
Service agent: Change
interior lighting
Surface of infrared door sensor is cov-
ered by condensate water
Clean the surface of the
infrared door sensor
Fault Possible cause Solution