MaCave Setting up and connecting the appliance
18
7 Setting up and connecting the
appliance
7.1 Notes on setting up the appliance
S17G, S46G, S118G and ST198D can be placed free-standing.
When selecting the location, observe the following instructions:
z The ambient temperature should be in accordance with the climate class
mentioned for your country in the supplementary brochure. Otherwise, it
is possible that the inner temperature you set cannot be reached or main-
tained. This could also be the case if there are extreme fluctuations in the
ambient temperature.
z The appliance should stand in the coldest part of the room, away from
heat sources (ovens, heating devices or radiators).
z The location must not be damp or wet.
z The appliance must not be exposed to direct sunlight. This can damage
the acrylic coating and lead to higher power consumption.
z The ground must be level and sufficiently stable to support the wine cellar
at full capacity.
z The appliance must be sufficiently ventilated. The ventilation slots on the
front of the appliance must not be obstructed.
z Note the information on the electrical connection, see chapter “Notes on
the electrical connections” on page 45.
z Remove all the inner and outer packaging material before setting up.
z Make sure the appliance is level by adjusting the feet.
7.2 Notes on installing the appliance
A
NOTICE!
z When mounting ensure that the ventilation openings
are kept
free. Covered ventilation openings result in an increase of
electricity consumption and
can damage the device.
z When pushing the appliance into place, ensure that the ma
ins
ca
ble does not get pinched.
To Next Page
Loading...
Need help?
General
