Illustration 5
12. Bend the lid and remove it with the mineral wool.
Attention: Wear gloves – danger of injury from sharp edges.
13. Remove the heating element.
14. Remove the condensed water container.
15. The cooling unit should be emptied by an authorized recycling company.
See the Information section.
16. The cabinet should be scrapped. See the guide section.
Table
No. Component Tool Recyclable / Waste
1
Racks None Plastic
1
or metal
2
Door rack None Plastic
1
3
Thermostat Flat-tip screwdriver Plastic
1
and electrical wiring
4
Feet Phillips screwdriver Plastic
1
5
Thermo-knob Pliers Plastic
1
6
Evaporator fins Phillips screwdriver Aluminium
7
Interior light Flat-tip screwdriver Electrical waste
8
Door Phillips screwdriver Plastic
1
, metal and PU foam
2
9
Cover Phillips screwdriver Plastic
1
10
Electrical wiring Pointed pliers Electrical waste
11
Cooling unit Phillips screwdriver Metal
12
Boiler insulation Flat-tip screwdriver
Metal Mineral wool
13
Heating element Flat-tip screwdriver Electrical scrap
14
Condensed water
container
None Plastic
1
15
Cooling media Special equipment
Ammonium, sodium chromate, hydrogen
Hazardous to the environment; toxic waste
16
Cabinet Shredder Plastic
1
, metal and PU foam²
1
The exact type of plastic material is stated in the case of plastic components weighing more than 50g
2
Cabinets not marked “Pentan” contain CFC/HCFC.
12
13
14
To Previous Page
Loading...
Need help?
General
