- 8 -
OPERATING INSTRUCTIONS
Before starting the refrigerator:
Check that all the manual gas valves are in the ON position.
This includes the manual shutoff valve at the rear of the
refrigerator.
Make sure that a continuous 12V DC supply is available for
the electronic control to function.
To start the refrigerator:
Press the ON/OFF button.
Select operation mode:
AUTO - AES/AUTO mode
AC and GAS.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button (if not already on). The illuminated
lamp indicates the selected mode.
(If the CHECK indicator lamp is illuminated, see
REFRIGERATOR OVERVIEW > MODES OF
OPERATION > AUTO MODE - AES/AUTO MODE for
further information.)
GAS mode
GAS operation only.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button to turn off the AUTO mode (if not
already off).
(Within 45 seconds the burner should be ignited
and operating normally. If not, see REFRIGERA-
TOR OVERVIEW > MODES OF OPERATION > GAS
MODE for further information.)
DC mode (3-way models only)
Press the DC mode indicator button. The DC lamp
will be turned on. To select AUTO or GAS mode,
turn off the DC mode by pressing the DC mode se-
lector button. The DC lamp will then be turned off.
If necessary, adjust the thermostat by pressing the
Temperature selector button.
(RM2351-2451-2551-2652-2852: The temperature
is controlled by a factory preset temperature setting.)
•
•
1.
2.
•
•
•
3.
TURNING ON THE CLIMATE CONTROL
RM2652-2662-2663-2852-2862, NDR1062 & NDR1292
Turn the Climate control switch to I (ON).
RM3862, NDR1062 & NDR1292
Press the CLC button. The indicator lamp will
illuminate.
TURNING ON THE LOW AMBIENT CONTROL
NDR1062 & NDR1292
Turn the Low ambient control switch to I (ON).
RM3862, NDR1062 & NDR1292
Press the LAC button. The indicator lamp will
illuminate.
TURNING OFF THE REFRIGERATOR
The refrigerator may be shut off while in any mode of opera-
tion by pressing the main power ON/OFF button to the OFF
position. This shuts off all DC power to the refrigerator, includ-
ing the interior light.
If the refrigerator will not be in operation for a period of weeks,
it should be emptied, defrosted, cleaned and the doors left ajar.
The ice trays should also be dried and kept outside the cabinet.
The Low ambient control
switch is located beneath
the top decoration panel
that houses the control
panel.
The Climate control
switch is located beneath
the top decoration panel
that houses the control
panel.
STARTUP
FIRE HAZARD. Before lighting the gas burner,
after that the RV has not been used for some
time, please check that the gas path between
the burner jet and the burner tube has not been
obstructed. Failure to heed this warning could
cause a re resulting in personal injury.