9
REFRIGERATOR REMOVAL
Shut off the gas supply at the LP tank.
back up wrench when loosening and tightening
connections.
Cap the gas supply line, loosen the screws an-
choring the refrigerator to the enclosure and slide
the refrigerator out of the compartment.
When replacing the refrigerator make sure that
the sealing strips are properly positioned.
Replacement is the reverse of removal. Check all
connections for gas leaks.
1.
2.
3.
4.
5.
6.
To mount the door panel - snap in
Open the door 90 degrees.
Remove the door decoration
Insert the vertical edges
into the grooves of the door
Push the panel downward
so that the lower horizontal
1.
2.
3.
4.
5.
INSTALLATION INSTRUCTIONS
Before leaving
Once the installation is complete, test the operation of the
refrigerator and instruct the user on it’s correct operation.
If the appliance fails to operate correctly, contact your local
To Next Page
Loading...
Need help?
General
