Dräger Alcotest 5000 User Manual

Intended use
13
en
4.4 Results
After 2 to 7 seconds (depending on the measured concentration and
the instrument temperature) the test result is shown in the display and
stored in the instrument. Two kinds of results are possible:
C) No alcohol detected. The test is passed. Additionally, the green LED
is lit. After 2 sec. the instrument will be ready for use again.
D) Alcohol detected. The test is failed. Additionally, the red LED is lit.
Press OK to proceed with the next measurement.
 During the sensor recovery time the display shows a rotating
process symbol.
 Repeat the procedure (see page 12 section "Performing the
measurement").
In the menu you can configure the confirmation of the test results
Alcohol and No alcohol as follows:
 Confirm the test results by pressing OK
or
 the test results are being confirmed automatically after 2 sec.
CD
00633785
27.12.2016 10:25 #00075
27.12.2016 10:25 #00075

Dräger Alcotest 5000 Specifications

General

Brand	Dräger
Model	Alcotest 5000
Category	Test Equipment
Language	English