4 5
ENEN
time. Allow the vacuum to cool down for
30 minutes before charging it.
•
When the vacuum is not in use, it can be
placed on the dust-removal hub.
•
The outlet of the power cord can be
adjusted according to users' needs.
Fig. C-1
Fig. C-2
Fig. C-3
Fig. D-1
Battery Status Indicator
Display Screen
Battery Status Display
Charging
Discharging
The number on the display screen
represents the current battery level in a
percentage during charging. When the
number becomes 100, the battery is fully
charged.
Blinking white
Charging
Battery Level ＜ 10%
Solid white
Fully charged
Battery Level ≥ 10%
O
How to Use
Display Screen
Troubleshooting
Fig. D-2
Fig. D-3
Fig. D-4
1. Trigger Switch Lock
Press briefly to enter/ exit the lock state.
2. Suction Level
The color of fan-shaped icon changes
with different modes.
3. Lock Status
4. Battery Level Percentage
When the display shows "LO", it indicates
that the battery level is lower than 10%.
5. Suction Level Switch
Press briefly to switch between eco, med
and turbo mode.
Note: The Med mode is used by default
every time the vacuum is turned on.
Low Battery Level
Blinking red: Battery level ≤ 10%
Out of Battery
Blinking red: Battery level ＝ 0%
Charging
Breathing red: Battery level ≤ 10%
Breathing green: Battery level ＞ 10%
Charging/Battery Level Indicator
Suction Level
Med Eco Turbo
If the vacuum is not working properly, the screen display will show an error message.
Please refer to the troubleshooting table to nd your solution.
Error Icon Status Error Message Solutions
Blinking orange Air duct blocked
Check whether the dust cup,
extension rod, multi-surface brush,
soft roller brush or motorized mini-
brush is blocked.
Blinking orange Brush roller stuck
Refer to the [Cleaning the Multi-
Surface Brush] section to clean the
debris and hair tangled on the brush
roller.
Solid orange Filter is expiring Please replace the lter in time.
Blinking red
High-
temperature
alert
Please wait until the motor
temperature returns normal.
If one of the error codes from E0 to E4 appears on the display screen, please contact the
after-sales service team.
Select from two working methods for the vacuum, which can be selected based on your
own needs.
Note:
• Use the trigger switch lock to free your fingers from fatigue caused by holding the
switch.
• Press the trigger switch lock again to quit Continuous Cleaning Mode.
Working Methods
Method 1: Discontinuous Cleaning Mode
Press and hold the power button to start the appliance, and release the button to stop
immediately.
Method 2: Continuous Cleaning Mode (Trigger Switch Lock)
Press the trigger switch lock to switch to Continuous Cleaning Mode, and then briefly
press the power button to keep the vacuum in Continuous Cleaning Mode.
To Next Page
Loading...
Need help?
General
