EU Declaration of Conformity
This product is carrying the CE-Mark in
accordance with the related European Directives.
Responsible for CE-Marking is Dynabook Europe
GmbH, Stresemannallee 4b, 41460 Neuss,
Germany. The complete and official EU
Declaration of Conformity can be found on the web
site http://emea.dynabook.com/product-conformity
on the Internet.
CE compliance
Hereby, Dynabook Europe GmbH declares that the model(s) described in
this manual is/are in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
internet address:
http://emea.dynabook.com/product-conformity.
This product is labeled with the CE Mark in accordance with the essential
requirements and other relevant provisions of the applicable European
Directives, notably Radio Equipment Directive (2014/53/EU), RoHS
Directive 2011/65/EU, Ecodesign Directive 2009/125/EC (ErP) and the
related implementing measures.
This product and the original options are designed to observe the
applicable EMC (Electromagnetic Compatibility) standards. However,
Dynabook cannot guarantee that this product still observes these EMC
standards if options or cables not produced by Dynabook are connected or
implemented. In this case the persons who have connected/implemented
those options/cables have to provide assurance that the system (PC plus
options/cables) still fulfils the required standards. To avoid in general EMC
problems, the following guidance should be noted:
Only CE marked options should be connected/implemented.
Only best shielded cables should be connected.
Working environment
This product was designed to fulfil the EMC (Electromagnetic Compatibility)
requirements to be observed for so-called “residential, commercial and light
industry environments”. Dynabook do not recommend the use of this
product in working environments other than the above listed working
environment.
For example, the following environments are not verified:
Industrial environments (e.g. environments where a mains voltage of
380 V three-phase is used)
Medical environments (according to Medical Device Directive)
Automotive environments
Aircraft environments
User's Manual 1-4
To Next Page
Loading...
Need help?
General