Controls
Heating mode
Cool air mode
Each time the heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration
cycle is complete, it will revert to the selected airflow
speed.
On first use, the heater will default to a temperature
1°C higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set.
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from
red to blue. To adjust the airflow speed use the airflow
speed control.
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red.
For best results turn on the oscillation control.
Select a high flow of air.
Select a low flow of air.
To return to heating mode
Whole room
Spot heat
1. Power on 2. Thermostat control
Select the desired room temperature. Pressing red
increases the target temperature, blue decreases
it. The heater will not operate unless the target
temperature is above the room temperature.
To Next Page
Loading...
Need help?
General
