Eaton 600 A 15 kV class push-OP User Manual

Displayed when an alarm is to be acknowledged or
unacknowledged by the user:
•
(ACKNOWLEDGE)
•
(UNACKNOWLEDGE)
Displayed when accessing USB Memory Drive operations:
•
(NO FILES FOUND)
•
(READING FILES...)
•
(REPLACE FILE)
•
(LOADING...)
•
(LOAD COMPLETE)
•
(LOAD FAILED)
•
(SAVING...)
•
(SAVE COMPLETE)
•
(SAVE FAILED)
•
(UPGRADING...)
•
(UPGRADE COMPLETE)
•
(UPGRADE FAILED)
•
(REMOVING...)
•
(OK TO REMOVE)
•
(REMOVE FAILED)
•
(USB NOT CONNECTED)
•
(CANCELLING...)
•
(CANCEL COMPLETE)
Displayed when indicating that the values for “Load Voltage
Secondary” and “Source Voltage Secondary” have been
derived by the control:
•
(CALCULATED)
Displayed when indicating that alternate configuration is
active:
•
(ALT CONFIG 1)
•
(ALT CONFIG 2)
•
(ALT CONFIG 3)
Displayed when indicating that changing Internal PT ratio is
not applicable because Vin PT configuration is invalid:
•
(INVALID VIN CONFIG)
Displayed when indicating inconsistencies between the
neutral signal and Tap Position value entered by the user:
•
(TAP AT NEUTRAL)
•
(TAP NOT AT NEUTRAL)
•
(MEASURED TP ACTIVE)
Displayed when testing the battery:
•
(TESTING...)
•
(ATTENTION)
Displayed when contact output cannot be overridden:
•
(CANNOT OVERRIDE)
Displayed when accessing Extended Comms Status:
•
(NOT AVAILABLE)
•
(RUNNING OK)
•
(FAILURE)
Displayed when accessing Metering PLUS screens for
LoopShare:
•
(LOOPSHARE INACTIVE)
Displayed when performing a firmware upgrade:
•
Do Not Remove Drive (USB Drive)
•
Restoring Settings
122
INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS MN225003EN April 2018
CL-7 Voltage Regulator Control

Eaton 600 A 15 kV class push-OP Specifications

General

Brand	Eaton
Model	600 A 15 kV class push-OP
Category	Cables and connectors
Language	English