10 5 INCH CHIPPER/SHREDDER
Section
To prevent personal injury or property damage: shut
o engine and make sure that all moving parts have
come to a complete stop before, servicing, adjusting or
repairing. Disconnect the battery and remove ignition
key where applicable.
WARNING
5 SERVICE & MAINTENANCE
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
SERVICE AND MAINTENANCE SCHEDULE
FREQUENCY
COMPONENT MAINTENANCE REQUIRED
BEFORE
EACH
USE
EVERY 8
HOURS
EVERY
25
HOURS
EVERY
50
HOURS
All internal and external
nuts and bolts
Check tightness ●
Chipper anvil
Check clearance and re-torque to
75 ft‑lbs. (1)
●
Chipper blades
Check sharpness and re-torque to
25 ft‑lbs. (2)
●
Shredder knives Check condition ●
Entire machine Clean ●
PTO cross journals Lube ●
PTO inner tubes Lube ●
PTO shield retaining
bearing
Lube ●
Drive belt Check ●
Belt tension Check ●
Belt/pulley alignment Check ●
Grease zerks Lube ●
(1) Perform more frequently under extremely dusty conditions.
(2) Perform more frequently when chipping dry or dirty wood.
As the Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine’s
warranty. The aggressive, high-speed nature of chipping REQUIRES THE OWNER TO PERFORM THE
ABOVE LISTED NORMAL MAINTENANCE. Special consideration to maintain and re-torque the CHIPPER
ANVIL, CHIPPER BLADES, and ALL INTERNAL AND EXTERNAL NUTS AND BOLTS is the sole responsibility
of the Owner. Failure by the Owner to do so shall be cause for denial of warranty.
5.1 MAINTENANCE SCHEDULE
To Next Page
Loading...
Need help?
General
