EasyManuals Logo
Home>Echo>Chainsaw>CS-2511WES

Echo CS-2511WES User Manual

Echo CS-2511WES
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28
Service
If you have any questions or problems, please contact your ECHO dealer.
Air filter
Check before every use.
Close choke.
Undo the cleaner cover latch, lift the tip of the air cleaner cover, then slide it sideways
and remove it.
Remove the air filter by turning it anticlockwise by hand.
Brush off dust lightly, or wash it in a non-inflammable solvent if necessary, or replace the
air filter.
Dry it completely before installation.
Align the air filter mark with the mark on the body then turn the air filter to the right and
attach it.
Insert the air cleaner cover into the rear handle side and push it forward, then fix it with
the cleaner cover latch.
Check fuel system
Check before every use.
After refuelling, make sure fuel does not leak or exude from around fuel pipe, fuel grommet
or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using he machine immediately and request your dealer to inspect or replace.
Fuel filter
1. Fuel filter
2. Fuel tank cap
Check periodically.
- Do not allow dust to enter fuel tank.
- A clogged filter will cause difficulty in starting engine or abnormalities in engine perfor-
mance.
- Pick up the fuel filter through fuel inlet port with a piece of steel wire or the like.
- When the filter is dirty, replace it.
- When the inside of the fuel tank is dirty, it can be cleaned by rinsing the tank out with
petrol.
Oil filter
1. Oil filter
2. Oil tank cap
Check periodically.
- Do not allow dust to enter oil tank.
- A clogged oil filter will affect the normal lubricating system.
- Pick it up through oil filling hole with a piece of steel wire or the like.
- If the filter is dirty, wash it in petrol or replace it.
- When the inside of the oil tank gets dirty, it can be cleaned by rinsing the tank out with
petrol.
Spark plug
Spark plug gap: 1.0 mm
Check periodically.
- The standard spark gap is 1.0 mm.
- Correct the spark gap if it is wider or narrower than the standard gap.
Fastening torque: 10 to 15 N•m (100 to 150 kgf•cm)
1. Cleaner cover latch 2. Air cleaner cover 3. Air filter
4. Mark
DANGER
Petrol and fuel are extremely flammable.
Extreme caution is required when handling petrol or fuel.

Other manuals for Echo CS-2511WES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Echo CS-2511WES and is the answer not in the manual?

Echo CS-2511WES Specifications

General IconGeneral
BrandEcho
ModelCS-2511WES
CategoryChainsaw
LanguageEnglish

Related product manuals