Don't cut with the saw overhead or the bar in a vertical
position. If the saw should kick back you may not have
good enough control to prevent possible injury.
BUCKING
Uphill position
Bucking is the sawing of a log or fallen tree into smaller
pieces. There are a few basic rules which apply to all buck-
ing operations.
Keep both hands on the handles at all times.
Support logs if possible.
When cutting on a slope or hillside, always stand uphill.
FINISH CUT
• FIRST CUT I'x\\\_\
Keep in mind that the wood is heavy and that it will bend
and pinch the saw if improperly supported.
The trunk will weaken at the point where you make the
cut unless the tree is lying on perfectly flat ground or sup-
ported as shown.
If you make the cut with the tree on the ground, don't let
the saw's chain dig into the earth; it is harmful for the saw,
and you stand a good chance of being struck by flying
debris. To cut the trunk, use the bucking and two-cut
sequence shown. The first cut should be no deeper than
one-third the trunk diameter.
Kickback Motion:
• When the bar nose hits another tree etc.
WARNING: KICKBACK IS DANGEROUS
• Kickback is generated when the rotation of the chain is
arrested for some reason. The most dangerous effect of
this action occurs when the nose of the bar contacts
another object, the chain is momentarily stopped and all
the energy of engine throws the bar upwards and backwards
towards the operator.
• The chain saw industry and government agencies have
attempted to prescribe various safety devices, but the best
protection isto avoid kickback.
• Comply with the Safety Precautions as listed on page 1
of this manual.
SEE OPERATOR'S MANUAL INSERT FOR INSTALLA-
TION AND USE WITH THE KICK GUARD.
• Improper thrust cutting.
-12-
To Next Page
Need help?
General
