14
CS-500P
CHAIN LUBRICANT
Proper lubrication of the chain while in operation
reduces the friction between the chain and the
guide bar to a minimum and assures a longer
service life.
• Use bar and chain oil of high quality for this
purpose.
• Do not use used or reclaimed oil to avoid various
oiler problems.
• Use ECHO bar and chain oil.
• When ECHO bar and chain oil is not available:
Use motor oil, etc.
• Use bar and chain oil of the following grades:
SAE No. 30 .......in summer
SAE No. 10 .......in winter or when cutting
resinous trees.
• When refueling, also refill chain oil.
OPERATION
WARNING
• After choke control knob is pulled and then
knob is returned to original position,
throttle remains a little open (latch
condition).
• If engine is started in this latch condition,
chain starts to turn. Do not start engine
before chain brake is locked.
CAUTION
• After starting the engine, squeeze throttle
trigger slightly to release throttle latch and
pull front hand guard towards the operator
immediately.
(Chain brake unlocked position)
• Never use throttle latch for cutting.
• Use the chain brake only in starting or in
emergencies.
Oil tank cap Fuel tank cap
Cap indication
Oil/fuel tanks are indicated by the following
illustrations on the caps.
Starter handle
Ignition switch
Unlock chain brake
Chain brake
Throttle trigger
lockout
Throttle trigger
Choke
To Next Page
Loading...
Need help?
General
