10
STARTING WARM ENGINE
1. Turn ignition switch to START position.
2. Move choke control lever down to OPEN position.
3. Push purge bulb 3 to 4 times or until fuel is visible in
clear fuel return line.
4. Pull starter handle.
STOPPING ENGINE
1. Release throttle trigger and allow engine to idle.
2. Turn ignition switch to STOP position.
NOTE
If engine does not starting after four pulls, use cold
starting procedure.
WARNING DANGER
IF ENGINE DOES NOT STOP, MOVE CHOKE
LEVER TO CLOSED POSITION. CHECK AND
REPLACE THE IGNITION SWITCH BEFORE
STARTING THE ENGINE AGAIN.
Ignition switch
STOP
Throttle trigger
HC-1500
HC-1600
Ignition switch
STOP
Starter handle
To Next Page
Loading...
Need help?
General