10
ASSEMBLY
WARNING DANGER
Never perform maintenance or assembly procedures with engine
running or serious personal injury may result.
INSTALL BLOWER PIPES
1. Remove elbow retaining screw from blower housing.
2. Align grooves in elbow with pegs on blower housing and slide
elbow onto housing.
3. Turn elbow clockwise to lock into place and align location holes
(A) in elbow and blower housing.
4. Insert elbow retaining screw through holes (A) and tighten.
5. Assemble clamps (B) onto both ends of flexible pipe (C).
6. Assemble straight pipe with swivel (D) into flexible pipe (C) and
tighten clamp (B).
7. Assemble flexible pipe (C) to elbow (E) on blower and tighten
clamp (B).
NOTE
A light lubricant may be used to ease assembly of flexible pipe to
blower elbow.
8. Loosen wing nut (F) completely and expand stick handle (G).
9. Align notch (H) in handle clamp with pipe pegs (J). Handle should
be angled away from operator.
10. Slide handle onto swivel pipe.
11. Position handle for comfortable operation and tighten wing nut.
12. Assemble straight pipes (K and L) to swivel pipe, turning straight
pipe clockwise to lock in place.
K
L
H
G
J
J
A
A
E
K
BC
D
F
G
L
B
F
To Next Page
Loading...
Need help?
General