GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
19
0.65 mm
(0.026 in.)
SPARK PLUG
Level 2.
Tools required: T-Wrench, feeler gauge, soft metal brush
Parts Required: REPOWER
TM
Tune-Up Kit P/N 90075C
IMPORTANT
Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) other-
wise severe engine damage may occur.
1. Remove spark plug and check for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kg/cm (130-150 in. lb.).
COOLING SYSTEM
Level 2.
Tools required: Cross Head Screwdriver, 4 mm Hex Wrench, Cleaning
Brush, 25 - 50 mm (1 - 2 in.)
Parts Required: None if you are careful.
IMPORTANT
To maintain proper engine operating temperatures, cooling air
must pass freely through the cylinder fin area. This flow of air
carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and grass build up on the outside of the cylinder. This build up
insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cooling fins is
considered “Normal Maintenance.” Any failure attributed to lack of
maintenance is not warranted.
To Next Page
Loading...
Need help?
General