GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
13
8 Tooth Weed/Grass Blade (P/N 69600120331) is designed for grass,
garden debris and thick weeds. DO NOT use this blade for brush or
heavy woody growth, 3/4" in. (19 mm) diameter or larger.
Brush/Clearing Blade (P/N 69500120330) is designed for cutting brush
and woody growth up to 3" in. (76 mm) diameter.
Use Shoulder/Waist Harness (P/N 30100052131) Use of the Shoulder/
Waist Harness reduces operator fatigue and the possibility of blade
contact with the operators hands and feet by restricting trimmer
movement.
HARNESS CLAMP INSTALLATION
(Plastic or Nylon Blade Use)
Tools Required: Screwdriver, 8mm x 10mm Open End Wrench.
1. Remove shield and gear housing as an assembly.
a. Loosen two (2) screws (A) that clamp the gear housing to the
drive shaft housing.
b. Remove locating screw (B) found at the top of the gear
housing. Pull shield and gear housing assembly from the drive
shaft assembly.
IMPORTANT
Prevent drive shaft from sliding from drive shaft housing. If shaft
does slide free, clean dirt from shaft and re-assemble.
A
B
A
To Next Page
Loading...
Need help?
General