EasyManuals Logo
Home>Echo>Trimmer>SRM-2655

Echo SRM-2655 User Manual

Echo SRM-2655
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
SRM-2655/2655SI
E
N
G
L
I
S
H
D
E
U
T
S
C
H
I
T
A
L
I
A
N
O
ANMERKUNG
Gerät vor dem Start auf lose Muttern,
Schraubbolzen und Schrauben überprüfen.
Vor dem Arbeitsbeginn alle Fremdkörper aus der
Arbeitszone entfernen.
Das Gerät stets fest auf dem Boden halten.
Beim Ziehen am Startergriff das Seil immer nur
kurze Stücke, d.h. auf 1/2 bis 2/3 der Seillänge,
herausziehen.
Den Anlassergriff nicht gegen das Gehäuse
zurückschnellen lassen.
NOTE
If engine does not start after 4 pulls, use Cold
Starting Procedure.
ANMERKUNG
Wenn der Motor nach viermal ziehen nicht anspringt,
Kaltstartverfahren anwenden.
NOTE
Check unit for loose nuts, bolts and screws before
starting.
Always clear work area of debris before starting
operation.
Always hold the unit firmly on the ground.
When pulling starter handle, use short pulls, 1/2 to
2/3 of rope length.
Do not allow the starter handle to snap back against
the housing.
N.B.
Prima dell’avviamento verificare che non vi siano
dadi, bulloni o viti allentati.
Prima di iniziare il lavoro sgomberare sempre
l’area di lavoro rimuovendo corpi estranei.
Tenere sempre l’attrezzo saldamente sul suolo.
Quando si usa la maniglia di avviamento tirare
sempre con brevi colpi pari di 1/2 a 2/3 la
lunghezza della fune.
Non lasciare che la maniglia di avviamento scatti
indietro contro la sede.
1
3
2
4
1. Choke lever
2. Purge bulb
3. Fuel return line
4. Starter handle
1. Chokehebel
2. Kraftstoffpumpe
3. Kraftstoffrücklaufleitung
4. Startergriff
1. Comand della farfalla
2. Pompetta di adescamento
3. Tubetto recupero carburante
4. Impugnatura di avviamento
STARTING WARM ENGINE
Place ignition switch in “START” position.
Move choke lever to OPEN position.
If tank is not empty, pull starter handle.
If fuel tank is empty, after refilling, push the purge bulb
(until fuel is visible in clear fuel return line). Pull starter
handle.
AVVIAMENTO A MOTORE CALDO
Spingere l’interruttore verso l’alto in posizione “START”.
Verificare che il comando della farfalla si trovi in
posizione APERTO.
Se il serbatoio non è vuoto, tirare la maniglia di
avviamento.
Se il serbatoio è vuoto, dopo aver fatto rifornimento
spingere il bulbo di spurgo (finché il carburante non è
visibile nel filo ritorno carburante). Tirare la maniglia di
avviamento.
START BEI WARMGELAUFENEM MOTOR
Zündschalter auf “START” nach oben schieben.
Sicherstellen, daß Choke geöffnet ist.
Falls sich Kraftstoff im Tank befindet kann der Motor
jetz gestartet werden.
Falls kein Kraftstoff im Tank ist - nachtanken und die
kraftstoffpumpe mehrfach drücken, bis der Kraftstoff in
der Kraftstoffrücklaufleitung wieder zu sechen ist. Am
Startergriff ziehen bis der Motor läuft.
N.B.
Se il motore non si avvia dopo 4 tiri usare la
procedura di avviamento a freddo.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Echo SRM-2655 and is the answer not in the manual?

Echo SRM-2655 Specifications

General IconGeneral
BrandEcho
ModelSRM-2655
CategoryTrimmer
LanguageEnglish

Related product manuals