18
D
F
H
G
D
E
400 mm (15-3/4 in.)
220 mm
(8-5/8 in.)
ENGINE
END
K
L
J
H
5. Loosen screws (D) and remove center shaft location bolt (E).
6. Loosen two (2) rear handle screws (F) and pull rear handle (G) from
the drive shaft assembly.
7. Loosen screw and pull harness clamp (H) from drive shaft
assembly.
8. Loosen four (4) screws and remove front handle (J).
9. Position lower U-Handle Bracket (K) 400mm (15-3/4 inches) from
engine end of drive shaft. Secure with three (3) 5mm x 30mm bolts.
10. Position harness hook 220mm (8-5/8 inches) from engine end of
drive shaft assembly. DO NOT tighten at this time.
11. Install upper U-Handle and bracket on lower bracket and secure
with one (1) 8mm x 55mm bolt (L) and large circular washer.
To Next Page
Loading...
Need help?
General
