GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
19
M
A
B
C
12. Secure throttle linkage and ignition leads to drive shaft with cable
ties supplied.
13. Install power head and align gear box, power head and
U-handles. Tighten all screws.
14. Place throttle linkage in slot in bracket. One nut and washer
on each side of bracket. Finger tighten both nuts (A).
15. Attach inner cable to swivel (B). Check throttle for freedom
of movement and that wide open throttle / low idle extremes
are adjusted properly. If adjustment cannot be achieved with
adjusting nuts, consult with your Echo Dealer for correct
adjustment procedure.
16. Attach ignition leads (C).
17. Balance unit.
a. Put on harness and attach unit to harness.
b. Slide harness clamp (M) up or down until unit balances with
head approximately 50-75mm (2in. - 3in.) from the ground.
c. Tighten harness clamp screw.
To Next Page
Loading...
Need help?
General
