GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
35
2. Use one piece of new nylon line (C) 12m (40 ft.) long and thread
through the molded loop (D) on the spool. Pull line tight and
adjust so one end is 15 cm (6 in.) longer than the other.
3. Hold spool with the tap knob in your hand and opening toward
you. Place index finger between the two lines and wind line
clockwise tightly and evenly.
4. Stop when approximately 15-20 cm (6" - 8") line (C) remains and
place ends of line in notches (E) in spool (B).
5. Feed ends of line through housing eyelets (F) and place spool (B)
over drive (G). Align pegs (H) on drive with notches in spool and
push spool into drum.
6. Pull on both lines until they come free from notches (E) in spool.
7. Hold drum (A) firmly and turn spool (B) CCW (counterclockwise)
until it stops. DO NOT push in on spool when turning.
8. Pull both lines out and trim to cut-off knife length.
To Next Page
Loading...
Need help?
General
