36
E
E
D
D
B
C
A
A
NYLON LINE REPLACEMENT
SRM-3100S, 3400
Tools Required: Head locking tool (if head is to be removed)
Parts Required: ECHO 0.105 in. Nylon Trimmer Line 15m (50 feet) long.
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Hold head firmly and push in cover tabs (A) to remove spool.
3. Use one piece of nylon line (B) and thread through the molded
loop (C) on the spool spindle until ends are even.
4. Hold spool with the tap knob in your hand and opening toward
you. Place index finger between the two lines and wind line
clockwise tightly and evenly.
5. When approximately 15-20 cm ( 6- 8in.) of line remains, place lines
in spool notches (D).
6. Place spool in housing against spring; thread line ends through
housing eyelets (E).
7. Align cover tabs with tab holes in housing and push until tabs
snap lock into place.
8. Pull on both lines until they come free from notches in spool.
9. Index line out by pushing tap knob and trim to cut-off knife length.
To Next Page
Loading...
Need help?
General
