16
LUBRICATION
Drive Shaft (Lower)
Level 1
Tools Required: 8 mm Wrench, Screwdriver
Parts Required: High Temperature automotive grease, Clean rag
IMPORTANT
Lower and upper drive shaft must be lubricated with high
temperature automotive grease every 25 hours of operation,
otherwise drive shaft assembly overheating and failure can
result.
1. Loosen clamping knob (D).
2. Pull locator pin (A) and rotate 1/4 turn counter clockwise to
lockout position.
3. Remove lower drive shaft assembly.
4. Remove lower flex cable, wipe clean and apply a thin coat
(1/2 oz. (15ml)) of high temperature automotive grease.
5. Install lower flex cable. Carefully fit lower drive shaft assembly
into coupler (B) to decal assembly line (C) making sure inner
lower flex cable engages into the upper drive shaft mount.
Drive Shaft (Upper)
1. Remove coupler from upper drive shaft assembly by loosening
clamping screw (E) and removing set screw (F).
2. Remove upper flex cable, wipe clean and apply a thin coat (1/2
oz. (15ml)) of high temperature automotive grease.
3. Install upper flex cable. Make sure that the flex cable engages
into the clutch mount and also into the coupler mount.
4. Install set screw (F) and tighten clamping screw (E).
D
A
B
C
F
E
A
B
C
D
To Next Page
Loading...
Need help?
General