10
Source Button
Press SOURCE briefly to cycle through the following modes:
BT (Bluetooth), AUX, FM, AM.
Play Music (Bluetooth Mode)
After the EcoXplorer is connected to your Bluetooth device, press
briefly on the EcoXplorer to play, press again to pause.
Press briefly to play previous song. Press briefly to advance to
the next song.
Press VOLUME to adjust the volume.
Notes:
· Pair and connect your Bluetooth device with EcoXplorer before using
this feature.
· If a call is received when you are listening to music, the music will
pause automatically.
· You can also control Volume and Play / Pause music operations from
your Bluetooth enabled device.
Radio Listening (AM/FM Mode)
Press SOURCE briefly to switch to FM or AM. Press RADIO to
tune in a radio station. To “seek” (jump to the next available station),
press and hold either button down for a few seconds until it starts to seek
a station.
Press VOLUME to adjust the volume.
EcoTalk
Press the EcoTalk button to activate the voice assistant on your device
(Siri, OK Google, etc.). Once activated, the speakerphone mic on your
EcoXplorer will hear your voice commands and transfer them to the voice
assistant on your device.
11
Notes:
·
Before using the EcoTalk function, your device must be connected to
the EcoXplorer via Bluetooth.
· Not all devices have voice assistant functionality; refer to your device
for details.
AM/FM Presets
Store a favorite radio station to quickly tune to a preset radio station.
There are 6 positions for AM stations and 6 positions for FM stations.
While listening to a station you want to store, press and hold a preset
button (P1~P6) to assign the current station to that preset number. The
LED screen will flash 2 times to indicate when a preset has been set.
If you want to listen to a stored preset, press a preset button (P1~P6) to
go to the stored radio station.
To Next Page
Loading...
Need help?
General