42
Using BIOS
Press <Esc> to return to the M.I.B.III Menu page.
RAS# to CAS# Delay(tRD) (5 CLK)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
RAS# Active Time(tRAS) (15 CLK)
This item specifies the RAS# active time.
Row Precharge Time(tRP) (5 CLK)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
CAS#Latency(tcl) (5 CLK)
This item determines the operation of DDR SDRAM memory CAS (column address
strobe). It is recommanded that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
Memory Clock (Auto)
This item is used to set the memory clock.
Memory Mode (Auto)
This item is used to set the memory Mode.
Memory Clock DCT0 is (DDR-1333/667Mhz)
This item shows current memory clock of DCT0.
Memory Clock DCT1 is (None)
This item shows current memory clock of DCT1.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.11.1210. Copyright (C) 2011, American Megatrends, Inc.
CPU Ratio [Manual]
CpuFid 5
CpuDid [/1]
Adjust CPU Ratio 21x(Fid=5,Did=1)
Current CPU Ratio 23x(Fid=30,Did=2)
Memory Clock [Auto]
Memory Mode [Auto]
Memory Clock DCT0 is : None
Memory Clock DCT1 is : (DDR-1066/533Mhz)
CAS# Latency (tCL) 5 CLK
RAS# to CAS# Delay (tRCD) 5 CLK
Row Precharge Time (tRP) 5 CLK
RAS# Active Time (tRAS) 15 CLK
Main Advanced Chipset M.I.B.III Boot Security Save & Exit
+/- : Change Opt.
lk
mn
: Select Screen
/Click: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Enter/Dbl Click : Select
Ratio = (CpuFid+16)/CpuDid
CpuDid
/1
/1.5
/2
/3
/4
/6
/8
/12
/16
To Next Page
Loading...
Need help?
General
