38
Using BIOS
Press <Esc> to return to the Integrated Peripherals page.
RAID Config (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
RAID Enable [Disabled]
SATA 1 Primary RAID Disabled
SATA 2 Secondary RAID Disabled
Item Help
Menu Level
Phoenix - Award WorkstationBIOS CMOS Setup Utility
RAID Config
IDE DMA transfer access (Enabled)
This item allows you to enable the transfer access of the IDE DMA then burst onto the
PCI bus and nonburstable transactions do not.
Primary/Seconday Master/Slave UDMA (Auto)
Each IDE channel supports a master device and a slave device. This motherboard supports
UltraDMA technology, which provides faster access to IDE devices.
If you install a device that supports UltraDMA, change the appropriate item on this list
to Auto. You may have to install the UltraDMA driver supplied with this motherboard in
order to use an UltraDMA device.
IDE Prefetch Mode (Enabled)
The onboard IDE drive interface supports IDE prefetching, for faster drive access. If you
install a primary and secondary add-in IDE interface, set this field to Disabled if the
interface does not support prefetching.
OnChip IDE Channel 1 (Enabled)
This item allows you to enable or disable the onboard IDEdevices.
Serial-ATA Controller (All Enabled)
This item allows you to enable or disable the onboard SATA devices.
X
X
Press <Esc> to return to the Integrated Peripherals page.
SATA Primary/Secondary RAID (Disabled)
These two items enable or disable the SATA Primary/Secondary RAID.
RAID Enable (Disabled)
This item allows you to enable or disable the onboard RAID function of RAID supporting
devices.
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults F10:Save
: Move Enter: Select +/-/PU/PD:Value ESC:Exit F1: General Help F2: Item Help
To Next Page
Loading...
Need help?
General
