33
Using BIOS
Integrated Peripherals
This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Integrated Peripherals
Onboard Floppy Controller Enabled
Serial Port1 Address 3F8&IRQ4
Serial Port2 Address 2F8/IRQ3
Serial Port2 Mode Normal
Parallel Port Address 378
Parallel Port Mode ECP
ECP Mode DMA Channel DMA3
Parallel Port IRQ IRQ7
Allows BIOS to Enable
or disable Floppy
Controller.
Help Item
SATA Configuration Enhanced
HDA Controller Enabled
Onboard LAN Function Enabled
Onboard LAN Boot ROM Disabled
USB Functions Enabled
Legacy USB Support Enabled
Onboard 1394 Function Enabled
OnBoard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1/2 Address (3F8/IRQ4/2F8/IRQ3)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port address.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Serial Port2 Mode (Normal)
If Serial Port 2 Address is not disabled, it allows you to set the Serial Port 2 Mode.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or BPP (Bi-
Directional Parallel Port).
HDA Controller (Enabled)
Use this item to show the Serial ATA Configuration options: Disabled, Compatible, En-
hanced.
Use this item to enable or disalbe the High Definition audio device.
ECP Mode DMA Channel (DMA3)
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move
mnlk
OnBoard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Use this item to assign a DMA channel to the parallel port.
SATA Configuration (Enhanced)
To Next Page
Loading...
Need help?
General
