34
Using BIOS
Integrated Peripherals
This page sets up some parameters for peripheral devices connected to the system.
SATA Configuration (IDE)
Use this item to show the Serial ATA Configuration options: Disabled, Compatible,
Enhanced.
Onboard SATA Mode (Enhanced)
Use this item to select the mode of the Serial ATA.
On Chip SATA2 Controller (AHCI Mode)
This item allows you to enable or disable the onchip Serial ATA controller.
Onboard AUDIO Function (Enabled)
Use this item to enable or disable the onboard Audio function.
Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable and disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Onboard 1394 Function (Enabled)
Use this item to enable or disable the onboard 1394 function.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
F9: Optimized Defaults
F1:General Help
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Integrated Peripherals
SATA Configuration IDE
Onboard SATA Mode Enhanced
On Chip SATA2 Controller AHCI Mode
Onboard AUDIO Function Enabled
Onboard LAN Function Enabled
Onboard LAN Boot ROM Disabled
Onboard 1394 Function Enabled
Serial Port1 Address 3F8/IRQ4
USB Functions Enabled
Legacy USB Support Enabled
Help Item
F10: Save ESC: Exit+/-/: Value
Enter : Select: Move
mnlk
Options
IDE
RAID
AHCI
Press <Esc> to return to the main menu setting page.
To Next Page
Loading...
Need help?
General
