14 ECTIVE MSP & SSP
2. Safety Instructions
2.1 Dangers
The installation of the ECTIVE solar modules may only be carried out by
competent specialists. The following must be observed:
• The installer himself is liable for injuries or accidents of any kind in the
course of installation.
• A single solar module generates DC voltages of 30 volts and more,
which can already lead to dangerous electric shocks. If several
modules are connected in series, the voltage of the individual modules
adds up to a correspondingly higher total voltage.
• Cover the solar module with an opaque material during installation
so that no solar current can be generated and thus there is no risk of
electric shock.
• Use only insulated tools approved for electrical work during
installation.
• When disconnecting the modules from the solar system, do not apply
any current. Ensure beforehand that the inverter is disconnected from
the power supply on both sides (DC and AC sides).
• Never carry out work on the solar system during rain or strong winds.
Use suitable fall protection for work on the roof.
• During transport, installation and maintenance of all components of
the photovoltaic system, all safety specifications of the manufacturers
must always be observed.
To Next Page
Loading...
Need help?
General
