Turning System On
Step 1 Turn on the source component you are going to
use (CD, DVD, DSS, etc)
Step 2 Make sure the volume is turned all the way down
Step 3 Turn on your preamplifier.
Step 4 Turn on your amplifier. It will take approximately
10 seconds before the warm up relay clicks in
and the amplifier is ready to play music. The logo
/ power display will come on as soon as the unit
is turned on and approximately 10 seconds later
you will hear the “click” of the relay. After “click”
proceed to Step 5.
Step 5 Select the source component on your
preamplifier corresponding to the source
you are going to listen to.
Step 6 Start the source component and slowly turn the
volume control up until you hear music.
Turning System Off
Step 1 ALWAYS turn your amplifier off FIRST, and wait
at least 5 minutes for power to drain*.
*WARNING:
The internal supply capacitors in EDGE amplifiers store large
amounts of energy, and can power your amplifier for several
minutes, even after the power switch is turned off. Always wait at
least 5 minutes before proceeding with shut down
of the system. Never unplug RCA cables while unit is on or
immediately after shut off
Step 2 Turn off your preamplifier.
Step 3 Turn off your source component.
Turning Unit On & Off
Specifications
NL 10 NL 12
chassis 1 1
# of transformers 2 2
# of channels 2 2
transformer rating 2 x 1000va 2 x 1500va
total capacitance 160,000uF 160,000uF
power rating into 8ohm 225 watts/channel 300 watts/channel
output impedance .03 ohms .025 ohms
input impedance 30,000ohms 30,000ohms
constant current capacity 27.73 amps 56.34 amps
# of lasers 2 2
input type RCA RCA
approximate weight 98 lbs 106 lbs
dimensions 19”dx15”wx9”h 19”dx15”wx9”h
page 7
page 8
To Next Page
Loading...
Need help?
General
