EasyManuals Logo
Home>EINHELL>Water Pump>GC-GP 6538

EINHELL GC-GP 6538 User Manual

EINHELL GC-GP 6538
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
GB
- 15 -
You are responsible for safety in the work
area.
If the power cable for this equipment is dama-
ged, it must be replaced by the manufacturer
or its after-sales service or similarly trained
personnel to avoid danger.
The voltage of 230 V alternating voltage spe-
cified on the rating plate must be the same as
the mains voltage.
Never use the power cable to lift, transport or
secure the equipment.
Ensure that the electrical plug connections
are in areas that are not at risk of flooding or
protect them from moisture.
Pull the mains plug before starting any work
on the equipment.
Do not expose the equipment to a direct jet of
water.
The operator is responsible for complying
with local safety and installation regulations.
(Ask an electrician if you are in any doubt.)
Consequential damage caused by flooded
rooms in the event of the equipment suffering
faults must be prevented by the user by me-
ans of suitable measures (for example instal-
ling alarm systems or a reserve pump, etc.).
In the event of a failure, repair work may only
be carried out by an electrician or by ISC after
sales service personnel.
The equipment must never run dry or be
used when the intake line is closed fully. The
manufacturer’s warranty does not cover da-
mage caused to the equipment as a result of
running it dry.
The pump must not be used to operate swim-
ming pools.
The equipment must not be installed in the
drinking water pipe line.
Take suitable measures to keep the equip-
ment out of the reach of children.
The operator is responsible for the safety of
other people in the work area.
Before starting, arrange for a specialist check
whether the required electrical safety measu-
res are in place.
2. Layout and items supplied
2.1 Layout (Fig. 1)
1. Pressure connector (R1 male thread)
2. Water drain screw
3. Suction connector (R1 male thread)
4. Water ller screw
5. Power switch
2.2 Items supplied
Please check that the article is complete as
speci ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
Open the packaging and take out the equip-
ment with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or su ocating!
Garden pump
Original operating instructions
Anl_SA_GC_GP_6538_SPK8.indb 15Anl_SA_GC_GP_6538_SPK8.indb 15 04.04.16 08:3704.04.16 08:37

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EINHELL GC-GP 6538 and is the answer not in the manual?

EINHELL GC-GP 6538 Specifications

General IconGeneral
Carrying handle(s)Yes
AC input voltage220-240 V
AC input frequency50 Hz
Flow rate3800 l/h
Delivery head36 m
Maximum suction height8 m
Maximum delivery height- m
Maximum operating pressure3.6 bar
Dimensions (WxDxH)200 x 365 x 220 mm
Proper useWater-supply
Product colorBlack, Red, Silver
Immersible-
Weight and Dimensions IconWeight and Dimensions
Weight6150 g

Related product manuals