EINHELL GC-WW 6538 User Manual

GB
- 17 -
11. Troubleshooting guide
Faults Cause Remedy
Motor fails to start
up
- No mains voltage
- Pump rotor blocked -thermostat
switched off
- Check voltage
- Dismantle and clean pump
No intake - Intake valve not in water
- Pump chamber without water con-
nection
- Air in intake line air-tight
- Intake valve leaks
- Strainer (intake valve) blocked
- Max. suction height exceeded
- Immerse intake valve in water
- Fill water into intake
- Make sure intake line is close
- Clean intake valve
- Clean strainer
- Check suction height
Inadequate delivery
rate
- Suction height too high
- Strainer dirty
- Water level falling rapidly
- Pump performance diminishedby
contaminants part
- Check suction height
- Clean strainer
- Place the suction hose at a deeper
level
- Clean pump and replace wearing
Thermostat swit-
ches pump off
- Motor overloaded - friction caused
by foreign substances too high
- Dismantle and clean pump. Prevent
intake of foreign substances (fi lter)
Anl_GC_WW_6538_Set_SPK1.indb 17Anl_GC_WW_6538_Set_SPK1.indb 17 23.09.15 10:0623.09.15 10:06

EINHELL GC-WW 6538 Specifications

General

Flow rate	3800 l/h
Maximum suction height	8 m
Maximum delivery height	36 m
Maximum operating pressure	3.6 bar
Maximum input water temperature	35 °C
Proper use	Garden
Product color	Black, Red
AC input voltage	220-240 V
Power cable type	H07RN-F
Power source type	AC
AC input frequency	50 Hz
International Protection (IP) code	IPX4
Cable length	1.4 m
Suction port	1\
Package depth	535 mm
Package width	305 mm
Package height	526 mm
Package weight	12130 g

Weight and Dimensions

Weight	10480 g