To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if my EINHELL Water Pump does not start?
If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
Why does my EINHELL GH-DP 7835 switch off after briefly running?
Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL GH-DP 7835 does not pump water?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL Water Pump has insufficient pumping rate?
An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
What to do if my EINHELL GH-DP 7835 Water Pump does not cut out?
If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
General| Brand | EINHELL |
|---|---|
| Model | GH-DP 7835 |
| Category | Water Pump |
| Language | English |
Identifies the main components of the submersible pump as shown in the diagram.
Lists all items provided in the product packaging.
Details stationary installation options using rigid pipes or flexible hoses.
Guide to setting the automatic on/off points for the floating switch.
Instructions for running the pump continuously with manual supervision.
Steps to dismantle and clean the pump's paddle wheel.
Information on routine checks and the absence of internal service parts.
Details on the required information for ordering spare parts.
