Leveling
LEVELING THE UNIT
1 Use a level to check the levelness of the ice maker
from front to back and from side to side (see Figure
11).
2 If the ice maker is not level, adjust the feet on the
corners of the unit as necessary (see Figure 12).
3 Check the levelness after each adjustment and
repeat the previous steps until the unit is level.
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
It is extremely important that the unit is level. If it is not level, the ice mold will not fill
evenly. This can cause a reduction in ice rate, uneven sized cubes or water spilling into
the storage area which will cause the ice in the bin to melt pre-maturely. Remember that
floors near drains have a tendency to slope towards the drain.
Figure 11
Figure 12
To Next Page
Loading...
Need help?
General
