32
Rinse aid
Rinse aid is automatically added during the last
rinse, ensuring thorough rinsing, and spot and
streak free drying. The dispenser, which is
positioned inside the door, holds about 110 ml of
rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by turning the lid (A)
anticlockwise.
2. Add the rinse aid until the container is completely
full. The indicator (B) will be completely dark.
3. Top up the rinse aid when the rinse aid indicator
light on the control panel illuminates.
If rinse aid refilling is necessary, the rinse
aid indicator light will illuminate only in
setting mode and at the end of the
washing programme.
During the run of the programme it will
remain off.
Ensure that the lid is closed after every refill.
Do not put liquid detergent in the rinse aid
compartment. Clean up any rinse aid spilt during
filling with an absorbent cloth to avoid excess
foaming during the next wash.
Adjusting the dose
According to the finish and drying results obtained,
adjust the dose of rinse aid by means of the 6
position selector (C) (position 1 minimum dosage,
position 6 maximum dosage).
Increase the dose if there are drops of water or lime
spots on the dishes after washing.
Reduce it if there are sticky whitish streaks on the
dishes.
To Next Page
Loading...
Need help?
General
