NOTE:
1. Do not pinch the power supply cord or the
flexible gas conduit between the range and
the wall.
2. Do not seal the range to the side cabinets.
3.24" (61 cm) minimum clearance between
the cooktop and the bottom of the cabinet
when the bottom of wood or metal cabinet
is protected by not less than ¼" (0,64 cm)
flame retardant millboard covered with
not less than No. 28 MSG sheet metal,
0,015 "(0,4 mm) stainless steel, 0,024"(0,6
mm) aluminum, or 0,020" (0,5 mm) copper.
30" (76,2 cm) minimum clearance when the
cabinet is unprotected.
4. For cutouts below 22 7/8"(58,1 cm),
appliance will slightly show out of the
cabinet.
5.Allow at least 19 ¼" (48,9 cm) clearance for
door depth when it is open.
Door Open
\ -
÷÷
÷
÷
÷
A
Side Panel
*** IMPORTANT: To avoid cooktop breakage for cutout width (E dimension) of more
than 30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening while
pushing into it. Raise leveling legs and the rear adjustable wheels at a higher position
than the cabinet height (see page 3), insert the appliance in the counter and then level.
Make sure the unit is supported by the leveling legs at the front and the
wheels at the back and NOT by the cooktop itself.
IM PORTANT: Cabinet and countertop
width should match the cutout width.
E
22 7/8"(58,1 cm) min.
23 1/4"(59,05 cm) max.
_ (see Note 4) __ F
- ........................................................i
_| _ 11/8"
/ (2,86 cm)
FRONT OF
CABINET H-- FRef.--_
A: HEIGHT B WIDTH C. CooKToP DI TOTAL DEPTH TO E. CUTOUT WIDTH*** F: CUTOUT G[ HEIGHT
(Under Cooktop) WIDTH FRONT OF RANGE (Countertop DEPTH OF COUNTERTOP
| and cabinet)
353/4"(90,8cm) 30"(76,2cm) 31 1/2" 285/16"(71,9cm) 30el/16" 21 3/4" (55,2 cm) Min. 353/4"(90,Scrn) Min.
(80 crn) (76,2e0,15 cm) 22 1/8" (56,2 crn) Max
36 5/8" (93 crn) 24" (61 cm) Min. with 36 5/8" (93 cm) Max.
backguard
To Next Page
Loading...
Need help?
General
