23
6. Remove fluff and objects from the
pump (if there are any).
7. Make sure that the impeller of the
pump can turn. If this does not occur,
contact the service centre.
8. Clean the filter under the water tap.
9. Put the filter back in the pump into
the special guides. Make sure that
you correctly tighten the filter to
prevent leakages.
10. Put the flap back and close the
drain pump door.
Remove the water inlet hose from
the water tap.
Clean the filter in the inlet hose with
a stiff brush.
5. Pull back the drainage duct and turn
the filter counter-clockwise to
remove it.
1
2
If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged. It is therefore
a good idea to clean it from time to time.
Cleaning The Water Inlet
Filter
8.8
To clean the water inlet filters:
1.
Close the water tap.
2.
3.
To Next Page
Loading...
Need help?
General
